Gavita Master Controllers EL1F & EL2F - Gen 2
Control up to 80 x Gavita lights and EC fans with an ELF Gavita Master Controller. They're just like the EL Gavita Master Controllers, only these ones take care of EC and AC fans too.
EL1F: 40 lights, 1 room, 1 EC fan output, 1 temperature sensor
EL2F: 80 lights, 2 rooms, 2 EC fan outputs, 2 temperature sensors, 2 ECMs (connects to heaters, CO2 equipment, etc)
If you opt for EL2F, you can run both rooms on the same, separate or overlapping light cycles.
- Up to 80 x Gavita lights
- Controls up to 8 x EC fans (4 per output)
- Can connect to AC fans (via EFM1 - not included)
Sunrise & Sunset Mode
Switch to Sunrise & Sunset mode to slowly dim and boost over 30 minutes!
Dim & Boost Lights In 10W Increments
You can adjust the light output of all connected lights in 10W increments
(from 50% to 115%)
If your grow room gets too hot, auto-dim and eventually emergency
shut down will kick in.
You get a warning before, and a notification after this happens.
No High Inrushes
All ballasts stay in standby mode until they get a signal from the controller
to switch on.
You check temperature highs and lows, last auto-dims, last auto-shutdown
Choose Your Display
Output: % or watts - Temperature: Celsius or Fahrenheit - Time: 24hr or AM/PM
External Contactor Modules (EL2F Only)
You can connect 2 extra bits of kit to your controller then choose whether
they switch on or off.
Easy To Use
Everything's plug & play.
|Max no of lights||40||80|
|Number of Rooms||1||2|
|External Contactor Modules (ECMs)||2 optional (connects CO2 equipment, heaters, etc)|
|Alarm contacts||2, nc/no|
|Temperature sensors||1||2 (1 per room)|
|EC Fan controls|
|EC fan control ouputs||1||2|
|Max no of fans||4||8|
|Fan control range||10 - 100%||10 - 100%|
|Extras (must be bought separately)|
|EFM1||Connects to AC fans|
|FB1||To run intake & outtake fans at different speeds|
|ECM1||External contactor modules|
|B200 Boosters||Maximum of 3 per port|