G.A.S Enviro Controller - V2

From £335.95

In stock

Grouped product items

G.A.S Enviro Controller - V2 Code: 5158	£335.95

G.A.S Enviro Controller - V2

Overview

Mix & match EC and AC fans! You can run both at the same time with one controller...a G.A.S Enviro Controller.

Overall, there's 1 x EC intake, 1 x EC outtake, 1 x AC intake, 1 x AC outtake. Run whatever fan combo suits you best!

EC fans (connects to EC Rev Vector, Silenced EC Rev Vector or HyperFan)
AC fans (2,200W single port, 3,000W total)

To connect Revolution Vector Fans, you need G.A.S Male-Male Lead (must buy separately)
To connect HyperFans, you can use the Male-Male lead your fan comes with.

There are also 2 x exit cables to connect:

Humidifiers
Dehumidifiers
Heaters
Light timer (up to 1,200W per exit cable)
Any timer (e.g. pump)

You can run 2,200W on each exit cable.

Don't go higher than 1,200W with grow lights - they have a high start up surge.

Smart Control

To keep your climate bang on, your fan speed works with other bits of kit.

You might need to run fans quickly to cool, but also activate your humidifier.

Fan Speed Balancer (Inbuilt)

You can run your intake fans and extractor fans at different speeds. Both intake fans run at the same speed, both extractor fans run at the same speed.

Day & Night Modes

You can have a different temperature and humidity for 'lights off' & 'lights on'.

Connect Up To 2400W Lights

That's 1,200W from each exit cable - 4 x 600W lights in total!

Waterproof To IP44

The unit's sealed to prevent any water ingress.

Dump Override For Closed-Loop (Optional)

For a couple of minutes at set intervals, fans are ramped up to max speed. All the air in your grow room is quickly replaced. This keeps your CO₂ high and stops your humidity rising. This feature overrides all other functions.

Technical Specification
Operating Voltage	230V / 50Hz
Max Amp	13A
Intake Fan Max	13A 2,200W
Outtake Fan Max	13A 2,200W
Exit 1 Max	2,200W
Exit 2 Max	2,200W

Note
Your controller can run up to 3,000W in total

Wattages

Overall, the whole unit runs at 3,000W, so:

If you only use EC fans, the whole 3,000W can go on your 2 x exit cables
If you use AC fans, you need to knock their wattage off the total unit's 3,000W.

e.g. if you run the total 2,200W for AC fans, you'd have 800W left to play with.

You can run no more than 2,200W on each exit cable. Don't go higher than 1,200W with grow lights, though because of their start up surge.

How to Use

Q & A

Write Your Own Question

Reviews