TopClimate Elite 6000 Air Conditioning Unit

Cool & heat with a fuss-free TopClimate Elite 6000 Air Conditioner.

• For 10 x 600W lights (6 x 1000W lights)
• Water-cooled unit

No refrigerant top ups or re-gassing is needed. Just connect your water & electricity, set your day & night temperatures. Your Top Climate Elite takes care of the rest.

• Cools + heats (also dehumidifies at night)
• Day & night mode
• Thermostatic control (temp, light & humidity sensors included)
• Plug & play with quick-fit plumbing (commissioned option)
• 5m wired controller
• No quibble manufacturer’s warranty.
  
  

You’ll need an electrician and plumber for installation, and there’s no commissioning certificate.

The unit’s been run, up, tested and adjusted for plug & play installation.

You wire into an external isolation switch, rather than going inside the unit.

There’s quick-fit plumbing for connecting the water.  No plumber is needed but we recommend an electrician.  The water flow rate has been adjusted to make sure it’s consistently at 1.5MPa. A commissioning certificate is included, showing this unit has been run up and tested in the UK. 

They’re smaller & lighter than most water cooled units. This is especially true for the bigger models - the biggest Top Climate isn’t much larger than the smallest ones.

They’re a lot like the fridges in your house. You can top up your refrigerant if you like, but there’s no need to.

There are no pressure points that could cause gas leaks when your unit is moved.

During lights off, it will remove humidity as your air is cooled. Water removed is collected in the condensation drain. You can reuse it as RO water for humidifiers and your nutrient solution!

When activated, these warm your grow room quickly

To reduce noise and prevent vibrations, compressors are built into a soundproof enclosure.

To keep water consumption low, there are built-in water valves. These ensure water is only used when it’s needed, keeping running costs low.

No difficult set up, no fine-tuning. Just connect your water & your electrical supply then set your temperatures. There’s quick-fit plumbing for connecting the water. You wire into an external isolation switch. We recommend an electrician does this.